I thought I needed to check the CH setting of the main unit, so I took it apart and found that it was CH1-R; 5658MHz.
I found out that it was responding to the protocol settings of the T8SG, but after looking around on youtube, I finally got it to fly.
I spent almost two days trying to figure it out, but without the Mr Kimata advice and YOUTUBE
I don't think I could have set it up without his advice and youtube.
https://www.youtube.com/watch?v=IyRmhPnOcB4
Makerfire Armor65 Lite BNF Crisp Review 03/27/2019
I am a little shocked that it is almost 3 years behind.
[ Jumper T8SGplus Stting : ]
ch5 = Simple SW D2
ch6 = Simple SW H1
ch10 = Simple SW G1
I'm not sure about the STAB/AIR mode, and it still bumps around a lot in a small room.
I can't control it at all. I still need a big space to get better.
I still need a spacious room to get better.